![]() ![]() If major elevation adjustments are needed, they should be accomplished by shimming the mount base. Certain mounts have integral windage adjustments and, when bore sighting, these should be used instead of the scope’s internal adjustments. Then sight through the scope and bring the crosshairs to the same point on the target. If a bore sighter is not available, it can be done as follows: Remove the bolt and sight through the gun barrel at a 100 yard target. It is best done using a Bushnell Bore Sighter. BORE SIGHTINGīore sighting is a preliminary procedure to achieve proper alignment of the scope with the rifle bore. Tighten the mounting screws as tight as possible. Rotate the scope in the rings until the reticle pattern is perpendicular to the bore and the elevation adjustment is on top.ĥ. WARNING: IF THE SCOPE IS NOT MOUNTED FAR ENOUGH FORWARD, ITS REARWARD MOTION MAY INJURE THE SHOOTER WHEN THE RIFLE RECOILS.Ĥ. Adjust the scope (either forward or backward) until you find the furthest point forward (to insure maximum eye relief) that allows you to see a full field of view. Before tightening the mount rings, look through the scope in your normal shooting position. Carefully follow the instructions packed with the scope mounts you have selected.ģ. The scope should be mounted as low as possible without touching either the barrel or the receiver.Ģ. Use a high-quality mount with bases designed to fit your particular rifle. (We strongly recommend that those unfamiliar with proper procedures have the scope mounted by a qualified gunsmith).ġ. To achieve the best accuracy from your rifle, your Bushnell scope must be mounted properly. Turn the fast-focus eyepiece clockwise or counter clockwise until the reticle pattern is sharp and clear. Then, shift your vision quickly, looking though the scope at a plain background. Simply look at a distant object for several seconds without using your scope. The eyepiece is designed to provide a precise fast focus. If the reticle appears unsharp, adjust as follows. If the reticle appears sharp, no adjustment is needed. All Bushnell riflescopes are focused at the factory for 20/20 or corrected vision. This adjusts the focus so that the reticle (cross hairs) appears sharp to your eyes. Bushnell AR Optics Rifle Scopes Instruction Manual EYEPIECE FOCUSING ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |